Move data labels inside pie segment

If you would like to move your data labels inside of your pie chart, this can be done in everviz from the basic customize panel. Below is an example of how the finished project will end up looking.

To achieve this:

1. Create a pie chart

2. Open the basic customize section

3. Open up the "Appearance" tab and use the "Label Distance" field. To move the labels inside the pie segment, you will more than likely need to set a negative value here.

If you do not see the "Label Distance" field in your editor, you may have a customize editor configuration set up. You can edit this by following along with the steps here.

Did you find what you were looking for? Thank you! There was a problem submitting your feedback. Please try again later.